EN PL

Hybrid pumps RC 6 series

Choose Models for offer request

Intended

  • Very high chemical resistance
  • Safety class IP 40
  • Capacity 5.9/6.9 m³/h
  • Final vacuum 2x10-3 mbar
  • Reduced internal corrosion, even when operating with corrosive vapors
  • Oil changes typically reduced by 90% or more compared to conventional pumps
  • Ease of maintenance due to telescopic design
  • Environmentally friendly
  • Pump filled with oil, ready to use
  • CE mark
  • Instruction manual
  • Warranty 12 months with possibility of extension

Combines a two-stage rotary vane pump and a two-stage chemical diaphragm pump to increase chemical resistance. The diaphragm pump keeps the oil reservoir under vacuum to keep the partial pressures of solvent vapors at levels below their condensation points which reduces the concentration of oxygen and corrosive gases. Therefore, hybrid pumps have a much higher resistance to aggressive gases than conventional rotary vane pumps.

Technical data:

  • Capacity 5.9/6.9 m³/h
  • Final vacuum 2x10-3 mbar
  • Safety class IP 40
  • Noise emission 50 dBA

THERMODYNAMIC PRINCIPLE OF HYBRID PUMP FUNCTION

1 - Steam is drawn in at low pressure and ambient temperature.

2 - The steam is heated to about 60 ° C by heat exchange and compression in the pump.

C - The problem of condensation in "normal" rotary vane pumps: On the way to atmospheric pressure, saturated vapor pressure (liquid transition) is reached inside the oil-filled section. The result: Condensation and corrosion inside the pump; oil contamination.

3 - Hybrid pump: The chemical diaphragm pump discharges vapors from the oil tank of the vane pump. Under the intended operating conditions, no condensation occurs inside the oil-filled part, especially in the oil tank. (Any condensation occurring in an oil-free diaphragm pump is much less problematic.) Less condensation means less corrosion and cleaner oil for longer life. For example, in the case of acid vapor, emptying the oil tank to 20 mbar reduces corrosion by about 50 times!

Optional equipment:

  • Shut-off valves e.g. VS 16, cat. no.: 20665004
  • FO oil mist filters for pumps
  • Separators installed on AK pump inlets
  • Vacuum valves e.g. VACUU-VIEW EXTENDED for monitoring process vacuum, cat. no.: 20683210
  • Vacuum controllers for monitoring and controlling process vacuum
  • Small flanges with hose spigot
  • Rubber vacuum tubes
  • Stainless steel tubes
  • PTFE tubes
  • Rotary pump oils B, K8 or perfluoropolyether oil, oils available in different capacities
Model Options
RC 6 pump Cat. no.: 20698560 -
Pump PC 3 / RC 6 Cat. no.: 22613307 Cold trap GKF 1000i / T-piece / VS16
Pump PC 8 / RC 6 Cat. no.: 20698570 EK - solvent recovery system